Small Aluminum Easel For Chromaluxe Mobile Memories Photo Panels – 3.5″ X 1.5″ (20/case)

The brushed silver aluminum easels come with pre-applied adhesive to be used for displaying ChromaLuxe Mobile Memories on the wall or on a table top.

Instructions on using metal easel with ChromaLuxe photo panels:

When using it as an easel:

• Lay the photo panel face-down on a clean surface.
• Remove the protective film from the adhesive square on the top section of the easel.
• Line up the bottom of the easel at the bottom-center of the photo panel. Once you have properly aligned it, press the top section firmly.
• WARNING: Do not press the taped area of the easel down until proper alignment has been finalized. The adhesive is strong and difficult to remove once set.
• While holding the panel firmly, bend the bottom section out to a 30-45 degree angle. Your panel is now ready to display.

When using it as a wall hanger:

• Lay the photo panel face-down on a clean surface.
• Bend the top loop of the easel out at approximately a 45 degree angle.
• Remove the protective film from the adhesive square on the top section of the easel.
• Visually align the easel to be near the top or centered (or as close to it as possible). Once you have properly aligned it, press the top section firmly.
• WARNING: Do not press the taped area of the easel down until proper alignment has been finalized. The adhesive is strong and difficult to remove once set.
• While holding the panel firmly, bend the bottom section out to a 15-20 degree angle. Your panel is now ready to display.